Cord Drawn Curtain Tracks Instructions

Once you have worked out were your track is going to go.

Cord drawn curtain tracks instructions.

Holding the cords taut push carrier 2 as far to the left as possible. Cord on overlap master carrier as original. To drill holes identify where the holes should be positioned and mark the track. Then feed cord around and over the top pulley g pass cord back through ovelrap master slide.

Remove the curtain rod from the. Remove the curtains from the traverse rods so you can access the cording. How to thread cord on curtain rails. 3 unhook cord from master carrier and allow to drop inside track.

Using a small bit drill pilot holes centered in the slot through the top of the track. Replace sliders at each end. Standard drill bits work fine on all aluminum tracks. If you re removing an old cord you can untie it.

Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley. Measure the rod s length while it is still on the wall. Add those two. Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud.

Then remove master carrier from the track. Most curtain tracks do not have the mounting holes pre drilled. Next place the rod face down on a flat surface. Click here for how to mend it.

8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor. Re attach track onto brackets and re hang curtains. Installing your styletrack curtain track. If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket.

Tension cord and tie off h. Curtain track features and how to install. Place pulley 2 onto track section and secure with screws. Hook cord over the lug on carrier 2 to secure it.

First you ll want to remove the curtain along with the curtain hooks from the rod and carriers. How to fit new cord to curtain tracks take measurements. Draw the cord until the right hand carrier 1 is as far to the right as possible.